PAGE 67 of 177
CX0344 Rev 05.3
5.7.5. Connecting/Disconnecting Left and Right Modules
TIP:
This operation is best performed with two people.
1.
Locate the release pin at the bottom of the
NAVIC
(Fig. 135)
. Using the
supplied 3 mm hex driver, press the pin while rotating the two modules
(Fig. 136).
2.
Once the two modules are 90° perpendicular
(Fig. 137)
, gently pull the two
modules apart
(Fig. 138)
.
CAUTION!
PINCH POINT HAZARD
. Keep
fingers clear of pinch points when connecting/
disconnecting left and right modules.
Fig. 135 - Press release pin
Fig. 136 - Press pin and rotate modules
Fig. 137 - Rotate modules to 90°
Fig. 138 - Pull modules apart
