PAGE 69 of 177
CX0344 Rev 05.3
5.7.6. Probe Holders
5.7.7. Vertical Probe Holder
A
Latch
B
Probe Holder Adjustment Knob
C
Vertical Adjustment Knob
D
Pivot Buttons
E
Probe Holder Arms
F
Yoke
G
Probe Holder Arm Adjustment Knob
H
Transverse Adjustment Screw
I
Frame Bar
5.7.7.1 Probe Holder Setup
1.
The probe holder adjustment knob allows the probe holder to be attached to
a frame bar, as well as horizontal positioning on a frame bar
(Fig. 142)
.
2.
Vertical adjustment knob allows the vertical probe holder height adjustment
(Fig. 143)
.
3.
Position the pivot buttons where necessary. When a narrow scanning footprint
is required, use the pivot button holes closet to the yoke
(Fig. 144)
.
TIP:
Probe pivoting may be impeded when closer to the yoke.
D
E
H
F
G
B
C
I
A
Fig. 141 - Vertical probe holder
Fig. 142 - Adjust on frame bar
Fig. 143 - Vertical adjustment
Fig. 144 - Place buttons