PAGE 80 of 177
5.7.8.4 Slip Joint Probe Holder Left/Right Conversion
To reverse the probe holder, follow these steps:
1.
Unscrew the yoke from the swing arm
(Fig. 183)
.
2.
Loosen the probe holder arm adjustment knob and arm clamp screw. Slide
the arms from the yoke
(Fig. 184)
.
3.
Flip the yoke 180° and reverse the probe holder arms
(Fig. 185)
.
4.
Place the pivot buttons on the inside of the probe holder arms
(Fig. 186)
using
a 3/8 in wrench
(Fig. 2)
. Slide the arms onto the yoke and tighten the probe
holder arm adjustment knob and the arm clamp screw.
Fig. 183 - Unscrew yoke pivot screw
Fig. 184 - Remove arms
Fig. 185 - Flip yoke and reverse arms
Fig. 186 - Attach arms and move buttons
