PAGE 81 of 177
CX0344 Rev 05.3
5.
Loosen the swing arm knob and slide the swing arm to the opposite end of
the probe holder bracket
(Fig. 187)
or preferred position. Tighten swing arm
knob.
6.
Using the 3 mm hex driver, screw the yoke pivot screw into the opposite side
of the probe holder swing arm
(Fig. 188)
. Ensure the yoke is level to avoid
issues with the plunger/set screw.
Fig. 187 - Position swing arm
Fig. 188 - Install yoke to swing arm
Fig. 189 - Reversed probe holder
