PAGE 86 of 177
5.
Position the pivot buttons to the
inside of the probe holder arms
(Fig. 203)
.
6.
Place the probe holder arms on
the yoke and tighten the arm clamp
screw and probe holder adjustment
knob
(Fig. 204)
.
7.
Screw the yoke to the probe holder
(Fig. 205)
.
TIP:
When using a standard
yoke length, position the
yoke in the threaded
hole closest to the frame
bar. When using a long
yoke length, position the
yoke in the threaded
hole furthest from the
frame bar.
5.7.9.4 Probe Holder 90° Adjustment
1.
Remove the yoke using the
supplied 3 mm hex driver
(Fig. 50).
2.
Orient the yoke to the front of the
probe holder and screw the yoke
into the threaded hole provided
(Fig. 206)
.
Fig. 205 - Screw into threaded hole
Fig. 206 - 90° probe holder positioning
