PAGE 9 of 42
BT0179 Rev 04.5
TIP:
If the umbilical does not slide freely from the body, you may need to push on the
wing knob to loosen the dovetail nut.
4.3.6. Front Pivot
The front pivot offers an attachment point for various frame bars.
To attach a frame bar, loosen both dovetail jaws enough to allow the frame bar
to be inserted and tighten the knobs
(Fig. 26)
.
The angle of the bar can be adjusted by loosening the side mounted lever,
pivoting to the desired angle, and closing the lever again
(Fig. 27)
.
4.3.7. Rear Pivot
The rear pivot is positioned at the rear of the cart body and provides an
attachment point for various frame bars. To mount a rear pivot follow these
steps:
1.
Release the side mounted lever and rotate the pivot down 90°
(Fig. 28).
2.
Align the rear pivot with the pins at the rear of the cart
(Fig. 29).
1
2
Fig. 26
- Frame bar attachment
1
2
Fig. 27
- Pivot
1
2
Fig. 28
- Rotate pivot 90° down
Fig. 29
- Position on cart body
