PAGE 15 of 42
BT0179 Rev 04.5
4.6.4. Slip Joint Probe Holder Left/Right Conversion
To reverse the probe holder, follow these steps:
1.
Unscrew the yoke from the swing arm
(Fig. 51)
.
2.
Loosen the probe holder arm adjustment knob and arm clamp screw. Slide
the arms from the yoke
(Fig. 52)
.
3.
Flip the yoke 180° and reverse the probe holder arms
(Fig. 53)
.
4.
Place the pivot buttons on the inside of the probe holder arms
(Fig. 54)
using
a 3/8 in wrench
(Fig. 15)
. Slide the arms onto the yoke and tighten the probe
holder arm adjustment knob and the arm clamp screw.
Fig. 51
- Unscrew yoke pivot screw
Fig. 52
- Remove arms
Fig. 53
- Flip yoke and reverse arms
Fig. 54
- Attach arms and move buttons