PAGE 18 of 42
To mount a UT wedge in the probe holder, follow these steps:
4.
Position the wedge on the inner probe holder arm
(Fig. 62)
.
TIP:
The probe holder yoke can accommodate many different probe and wedge
sizes of varying widths. It is best to centre the wedge with the yoke’s pivot
axis. This can reduce wedge tipping when scanning. Position the inner probe
holder arm accordingly (Fig. 62) using the supplied 3 mm hex driver (Fig. 14).
5.
Loosen the probe holder arm adjustment knob
(Fig. 63)
and slide the probe
holder arm along the yoke pinching the wedge in place.
6.
Tighten the probe holder arm adjustment knob
(Fig. 64)
.
Fig. 62
- Adjust inner arm
Fig. 63
- Adjust outer arm
Fig. 64
- Tighten arm knob