PAGE 35 of 140
DP0029 Rev 02.2
To configure the
SKOOT HT
system, follow these steps:
1.
Attach the
6
HT cable management to the
2
crawler.
2.
Connect the
11
power controller to the
2
crawler using the
8
umbilical.
3.
Connect
5
handheld controller to
12
cooler using the
9
auxiliary cable.
4.
Connect the
12
cooler to the
11
power controller using the
10
short auxiliary
cable.
5.
Connect the
3
blue hose to either port on the
2
crawler, Connect the opposite
end of the blue hose to the
OUT
port on the
12
cooler.
6.
Connect the
4
red hose to either port on the
2
crawler, Connect the opposite
end of the red hose to the
OUT
port on the
12
cooler.
7.
Route the
8
umbilical,
3
blue hose and the
4
red hose through
the
6
HT cable management.
(see Hose Connection and Routing on page 85 for
additional details).
8.
Connect the
1
user's instrument to the
11
power controller using the
7
encoder cable.
9.
Insert
13
AC/DC power supply into the
11
power controller.
10.
(see "Configurations" on page 36)
to setup a particular component.
CAUTION!
DO NOT DISCONNECT
UNDER LOAD.
Shut off power before connection or
disconnecting. Permanent damage to electronics
could occur.
