PAGE 61 of 140
DP0029 Rev 02.2
5.8.3. Slip Joint Probe Holder
A Frame Bar
B Probe Holder Adjustment Knob
C Latch
D Swing Arm Knob
E
Yoke
F
Probe Holder Arm Adjustment Knob
G Probe Holder Arm
H Arm Clamp Screw
I
Pivot Buttons
5.8.3.1 Probe Holder Setup
To mount a UT wedge in the probe holder, follow these steps:
1.
Rotate the probe holder adjustment knob and attach probe holder to a
frame bar
(Fig. 139)
.
2.
Use the probe holder adjustment knob to position the probe holder along
the frame bar
(Fig. 140).
F
I
A
C
B
D
E
G
H
Fig. 138 - Slip Joint Probe Holder
Fig. 139 - Attach to frame bar
Fig. 140 - Adjust on frame bar
Fig. 141 - Adjust swing arm
Fig. 142 - Place pivot buttons
