PAGE 69 of 142
DN0108 Rev 00
5.9.3.4 Slip Joint Probe Holder Left/Right Conversion
To reverse the probe holder, follow these steps:
1.
Unscrew the yoke from the swing arm
(Fig. 167)
.
2.
Loosen the probe holder arm adjustment knob and arm clamp screw.
Slide the arms from the yoke
(Fig. 168)
.
3.
Flip the yoke 180° and reverse the probe holder arms
(Fig. 169)
.
4.
Place the pivot buttons on the inside of the probe holder arms
(Fig. 170)
using a 3/8 in wrench
(Fig. 45)
. Slide the arms onto the yoke and tighten
the probe holder arm adjustment knob and the arm clamp screw.
Fig. 167 - Unscrew yoke pivot screw
Fig. 168 - Remove arms
Fig. 169 - Flip yoke and reverse arms
Fig. 170 - Attach arms and move buttons