No Diving or Jumping. Observe all Safety Rules
1-8
GENERAL INSTRUCTIONS - BRACELESS OVAL POOLS
GROUND PREPARATION
Section
1
C. PRE-ASSEMBLY OF THE T JOINTS (BUTTRESS)
1. Assembling the buttress joints
a. Insert the horizontal sleeves in the buttress joints.
On each side insert two or three (depending
on the side) 6.35 cm (2.5”) mechanical screws
(B14x20x212) with nuts (N14x20).
Note that the sleeve with the anchor holes should
be installed facing into the pool.
(Images 11 & 12)
b. Insert the vertical sleeve.
(Image 13)
11
12
Important Note:
The opening of the vertical sleeve must be facing the
outside of the pool.
Important Note:
Do not throw away the extruded polystyrene sections.
Inside of Pool
Outside of Pool
Inside of Pool
Outside of Pool
13
Inside of Pool
Outside of Pool
N14x20
B14x20x212
