No Diving or Jumping. Observe all Safety Rules
1-15
GENERAL INSTRUCTIONS - BRACELESS OVAL POOLS
GROUND PREPARATION
Section
1
E. ASSEMBLING THE BUTTRESS STRAPS AND PRESSURE PLATES
f.
Once both sides of the buttresses have been
installed perfectly, check that all is measured again
perfectly (diagonally and square).
(Image 28)
g. Add the remaining straps that join across to other
straps. Make sure the screw heads are facing
upward. Remeasure and tighten screws. Recheck
measurement again.
(Image 29)
h. Measure the two intersecting axes to ensure that
the two straight sections are parallel.
(Image 30)
2. Proceed to Section 2 -
Assembling the Pool Base
28
29
30
Note:
It may feel tedious to be always measuring, but this
only helps to ensure proper installation and avoiding
problems further on.
Important Note:
Ensure that the straps raise higher in the middle,
therefore you may need to put a little more stone dust
underneath, appx 1/2
”
. If you fail to do this the straps will
lift when the pool is filled with water.
1/2
”
stone dust
B38x16x34)
N38x16x34)
