To ensure correct operation, choose an interval at least two seconds longer than the exposure time.
When using autofocus, set the delay to two seconds or more and choose an interval at least two seconds
longer than the exposure time to ensure that the camera has time to focus. When using long exposure
noise reduction, the interval should be at least twice the exposure time.
Intervals of 00:00:00 will automatically be reset to 00:00:01 when the SET button is pressed to put
settings into effect.
To set the number of shots to - - (unlimited), select 1 and press the arrow button down or select 399
and press the arrow button up.
After adjusting all setting, press the SET button to put the new settings ENABLE. A beep will sound (If the
speaker is ON) and the “SET” icon indicator will go out.
Start
Start
Start
Start the
the
the
the timer
timer
timer
timer
Press the START/STOP button. The timer will start and “TIMER ACTIVE” will flash in the control panel.
Between shots, the control panel will show the time remaining until the next photograph is taken. If the
speaker is ON, a keep will sound three times at ONE-SECOND intervals before the shutter opens.
While the shutter is opened, the control panel will show the time remaining until the shutter closes, and
the release lamp and “RELEASE” indicator will flash at ONE-SECOND intervals. The number of shots
remaining will be updated each time a photograph is taken.
5.Speaker
1.
Flashes while timer is active
2.
Between
Between
Between
Between shots
shots
shots
shots
: Time remaining until next
shot.
While
While
While
While shutter
shutter
shutter
shutter is
is
is
is open
open
open
open
: Time remaining
until shutter closes.
3.
Number of shots remaining
4.
Flashes while shutter is open
