Drone Status Indicator
No.
1
Drone 2.4GHz disconnected.
2
Drone is in initial detection status.
3
No GPS signal, drone is in gesture mode.
4
Front light glows solid red, rear
light glows solid green.
Strong GPS signal, drone is ready
for GPS mode.
5
Drone is in gyroscope calibration status.
6
Drone is in compass horizontal calibration.
7
Front and rear lights flash green alternatively.
Drone is in compass vertical calibration.
8
Front light glows solid red, rear light
flashes red slowly.
Drone is nearly low voltage, 1/4
battery level left.
9
Front light glows solid red, rear light
flashes red rapidly.
Drone is in low voltage, only 1/6
voltage left.
10
Front and rear lights flash once, stop
for 1.5 second.
Something wrong with the gyroscope.
11
Front and rear lights flash twice, stop
for 1.5 second.
Something wrong with the barometer.
12
Front and rear lights flash three times, stop
for 1.5 second.
Something wrong with the compass.
13
Front and rear lights flash fourth times, stop
for 1.5 second.
Something wrong with the GPS module.
Indicator Status
Indication
Front and rear lights flash light green rapidly.
Front and rear lights flash red, light green and
green alternatively.
Front light glows solid red, rear light
glows solid light green.
Front and rear lights flash green rapidly.
The light green indicator lights on the front and
rear flash alternately.
Drone Initial Detection
After signal connection, the drone enters into initial detection procedure with front and rear
lights flashing red, green and light green alternatively. Make sure that the drone is set on a flat and
still surface for the initial detection. The drone initial detection takes about 8 seconds.
Once the remote controller sends out “Di Di” sounds and the drone front and rear lights flash light
green alternatively, initial detection is completed.
!
Attention: Make sure that the drone is set on a flat and still surface for the initial
detection.
-10-
