Slide the button to position “B” (indicated as below), the drone is in GPS mode and can precisely
position and hover by the assitance of the GPS module.
GPS Mode
Return-To-Home (RTH)
Smart RTH
If the GPS signal is available (more than 7 satellites is presented) and the Home Point is recorded
previously, press this button, the drone will fly back to the Home Point. During the smart RTH, you
can use the remote controller to guide the drone around obstacles. You can press the RTH button
again to exit RTH procedure and regain control of the drone.
Slide the Headless mode switch button to position “B” (indicated as below); the drone enters into
headless mode. When the drone is in headless mode, you’re required to position the drone in such a
way that its front is your front before the drone takes off. Then, when you take off the drone with the
drone pointing to the front, you can give up worrying about orientation during flight.
Headless Mode
The Return-to-Home (RTH) procedure brings the drone back to the last recorded Home
Point. There are 3 types of RTH procedures: smart RTH, failsafe RTH and low voltage RTH.
The following sections describe them in detail.
Home Point
The Home Point is the location at which the
drone takes off. A strong GPS signal must
be presented for the drone to record the
Home Point.
GPS
Description
A B
A B
OFF ON
Model
A B
A B
OFF ON
Model
OFF ON
-14-
