Low Voltage RTH
Photo/Video
Attention: When the drone is not inserted with TF card or the TF card is malfunction,
photos and videos taking can not be done.
!
Failsafe RTH
If the GPS signal is available (more than 7 satellites is presented) and the Home Point is recorded
previously. Failsafe RTH will be triggered if the remote controller signal is lost for more than 6 seconds,
the flight-control system will control the drone automatically and the drone will fly back to the last
recorded Home Point. You can regain control of the drone by pressing the RTH button if the remote
controller signal is recovered.
!
● During the Failsafe RTH procedure, the drone can not avoid obstacles.
● The drone cannot Return-to-Home if the GPS signal is weak (satellite amount
is less than 7).
● If there is no GPS signal and the remote controller signal interrupts for more than 6
seconds, the drone will not Return-to-Home but descend slowly until landing on to the
ground and locked.
!
Attention: When drone is in low voltage RTH status you can not regain control of the
drone by pressing the RTH button.
When the drone rear light flash red slowly, battery icon “ ” is shown on the LCD screen, and
steady beep, beep, beep..., beep, beep, beep sound is heard. At this moment, as long as the drone
flying altitude is over 100 meters or the flying distance is over 300 meters, the drone will automatically
fly back to the Home Point.
When the drone rear light flash red slowly, battery icon “ ” is shown on the LCD screen, and
steady beep.., beep..., beep sound is heard. At this moment, as long as the drone flying altitude is
over 15 meters or the flying distance is over 15 meters, the drone will automatically fly back to the
Home Point. If the drone flying altitude is less than 15 meters or the flying distance is less than 15
meters, the drone will automatically land on the ground.
Short-press the button indicated as below and the camera icon “ ” on the LCD screen flashes once,
the camera takes one photo; Long-press the same button, the video icon “ ” on the LCD screen
flashes slowly, the camera starts to take video. Long-press again to exit video mode.
OFF ON
Model
-15-