Forward
Left
Right
Forward/Backward
Backward
DF806
7
Initiate RTH mode,if the current flight height is less than 30meters,aircraft will automatically rise to
30meters to return,,if the current flight height is more than 30meters,aircraft will be returned directly.
Inability to manipulate the aircraft during RTH mode,please ensure that there is no obstacle in the
return route in case of accidents.
When the aircraft lands, please turn off the aircraft and the remote control power after the propeller stops rotating.
Caution:Please stay away from aircraft until propellers stop rotating completely.
9). Remove the battery and store it separately
(1). When finishing flight, please remove both batteries from the aircraft and remote controller and store separately.
(2). Keep batteries out ofthe reach of children and pets. DO NOT leave the battery near heat sources such as a furnace or
heater. DO NOT leave the batteries inside ofa vehicle on hot days. The ideal storage temperature is 22
℃
-28
℃
.
(3). When a battery is found to be damaged, strictly follow your local regulations regarding the disposal and recycling of
batteries.
10). Pair aircraft and RC
The aircraft has already paired with the remote controller by default. If the remote controller has been replaced, please pair again
complying with the following steps:
1) Switch on the drone and the remote controller.
2) Unlock your mobile phone, enter the menu “Settings-
WLAN” to view the Wi-Fi network list, among
which you can see “Drone-xxxxxx” (xxxxxx consists
of
c h a r a c t e r s a n d n u m b e r s ) o f t h e d r o n e a n d
“Controller-xxxxxx” of the remote controller (xxxxxx
consists of characters and numbers). Please take down
the serial number of the remote controller for further
reference.
3) Click the Wi-Fi network of the drone to connect.
4) Enter the APP interface and click “…” in the top right
corner to enter the menu.
5) Find “RC Paired” and click “Pair”.
6) A dialogue box will pop up. Type in the serial number of
the remoter controller in the box and click “Pair” to confirm.
7) Navigate your mobile phone to “Settings-WLAN” again to check the serial numbers of the drone and the remote controller. If the
two serial numbers are correct, the pairing will be successful, with the drone’s rear lights turning flashing green or solid green.
