JKEXER Turbo 772, Owner'S Manual

CAUTION:  
BEFORE AND AFTER RUNNING ON THE TREADMILL

Before Running: 

1.  Read the manual first for familiarization of the computer and other important features. 

2.  Before starting the treadmill, always stand on two side rails on both sides (not on the 

    running belt) as shown on drawing.

3.  Have safety key properly place on the computer console, and have safety clip securely 

    attach to an article of your clothing. 

4.  Start the treadmill and allow it to reach at speed of at least 1.0kph, hold your hand on the 

    handlebar then walk on the running belt to start your exercise program. 

After Running: 

1. If you hear any abnormal noise from motor, please stop using and contact with your 

    distributor for necessary maintenance. 

2. Please refer to below RUNNING DECK LUBRICATION to do necessary periodical 

    maintenance for long-term and functional operation.  

PLEASE NOTE WITHOUT DOING PERIODICAL MAINTENANCE MIGHT VOID THE 

WARRANTY. 

RUNNING DECK LUBRICATION 

Why to lubricate?

If the lubricant dries out, the friction between the belt and the deck will rise and place undue 
stress on the drive motor, drive belt and electronic motor control board, which could result in 
catastrophic failure of these expensive components. 

When to lubricate?

High-efficient and low-friction running deck is used on this machine. The deck comes pre-
lubricated and subsequent lubrication should be done in every 

120

 hours, or every 

3

 months of 

operation, whichever comes first. Keeping the deck lubricated at the recommended intervals 
ensures the longest life possible for your treadmill. 

3