Continued on Next Page
SMS-P-987C INSTR_SKU# 011358
Page 7 • JL Audio, Inc., 2013
S T E P 2 8
Push in on the four radio mounting tabs and slide the factory
radio out of the dash. Disconnect the wiring harnesses and
remove the radio.
S T E P 3 2
Connect 12 Gauge Speaker Cable to the terminal cup on the
enclosure, and set the Stealthbox® into position. Route the
12 Gauge Speaker Cable behind the driver’s side carpeted
panel toward the front of the vehicle. Tighten the Straps
around the enclosure as shown.
S T E P 2 7
Locate the two Allen head screws on each side of the radio.
Turn them 180 degrees counter clockwise to release the
radio mounting tabs.
Important:
Do not turn the Allen head screws past the
point of tension (approximately 180 degrees). They are not
designed to come out, and attempting so will damage the
radio mounting tabs.
S T E P 3 1
Locate the tie-down hooks on each side of the trunk, and
slide a Strap through the hooks.
S T E P 2 6
Remove the small Allen head screw from the driver’s side of
the factory radio.
S T E P 3 0
Empty out the trunk of the vehicle.
S T E P 2 5
Remove the two screws that hold on the side panel of the
radio console, and remove the panel.
S T E P 2 9
Using the color code in
Step 18
as a guide, cut the two pair
of front speaker wires a few inches from the plug. Connect
a pair of Speaker to RCA Adaptors to the plug side wires,
and connect 16 Gauge Speaker Cable to the opposite side.
Connect the RCA Cable to the Speaker to RCA Adaptors
Route the wires down toward the driver’s kick panel, and
reinstall the factory radio and four radio console panels.
