113242-3
23
TIMING LEGEND
SPIN TIME
Adjustment Position Number
1
2
3
4
5
Time in Seconds*
30
60
90
120
150
DWELL (STOP) TIME
Adjustment Position Number
1
2
3
4
5
Time in Seconds*
5
6.3
7.6
8.9
10.2
* Values shown are +/- 1-second.
Non-Coin Models
The light emitting diode (L.E.D.) display reads “READY” (no
cycle in progress).
Press the letter on the keyboard (touch pad) corresponding
to the cycle desired (i.e., key “D”).
Note
“0-40” will require the “start/enter” key to be
pressed after the number is selected in order to
accept the selection and start drying.
The dryer will then start. (I.E., blower, basket [tumbler], and
heat).
The L.E.D. display will read MANUAL DRYING CYCLE D, 00:00
MIN REMAIN.
Note
Press and hold the “UP ARROW” to view the
basket (tumbler) temperature at any time.
The dryer can be stopped at any time by pressing the
“STOP/CLEAR” key, at this time the dryer will go into a
cycle pause. If the “STOP/CLEAR” key is pressed again at
this point, the cycle that was in progress will be cancelled
and returned to the “READY” state.
Press and hold the “DOWN ARROW” to view the basket
(tumbler) RPM.
When the programmed drying time has expired, the Phase 7
non-coin microprocessor controller (computer) will proceed
into the Cool Down Cycle.
Once the Cool Down Cycle begins at the end of the heat
cycle, the L.E.D. display will read COOL DOWN TEMP ___/
___ MINUTES REMAINING. At the end of the heat cycle, the
dryer will shut off the heat and continue the fan and basket
(tumbler) until the Cool Down Time or temperature is reached.
Important
For more detailed information regarding the
microprocessor controller (computer) on your
dryer, refer to the microprocessor user’s manual included
with the dryer.
Dual Timer Dryers
Turn drying timer knob for a time of 20 minutes.
Select “High Temp.”
Push “Push to Start” switch.
To stop the dryer, open the main door.
Spin and dwell (stop) times are adjustable at the reversing
timer.
!
!
!
Reversing Timer Spin/Dwell Adjustments
Timer models have an electronic reversing timer in the
electrical service box, which is located in the upper left rear
area of the dryer.
Both the Dwell (stop) Time and the basket (tumbler) Spin
Time are adjustable by mode selection switches located on
the electronic timer (as noted in the illustration below).
Shutdown Instructions ______________
If the dryer is to be shutdown (taken out of service) for a
period of time, the following must be performed:
Discontinue power to the dryer either at the external disconnect
switch or the circuit breaker.
Discontinue the heat supply:
Gas Models
– discontinue the gas supply.
SHUT OFF external gas supply shutoff valve.
SHUT OFF internal gas supply shutoff valve located in the
gas valve burner area.
Steam Models
– discontinue the steam supply.
SHUT OFF external (location furnished) shutoff valve.
SHUT OFF internal steam valves in the supply lines and the
return lines.
