SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
3121165
– JLG Lift –
2-5
Figure 2-2. Walk - Around Inspection Points
GENERAL
Begin the “Walk-Around Inspection” at Item 1, as noted
on the diagram. Continue Left (counterclockwise viewed
from top) checking each item in sequence for the condi-
tions listed in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS
“OFF” DURING “WALK-AROUND INSPECTION”.
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDER-
SIDE. CHECKING THIS AREA OFTEN RESULTS IN DISCOVERY OF
CONDITIONS WHICH COULD CAUSE EXTENSIVE MACHINE DAM-
AGE.
NOTE: On each item, make sure there are no loose or
missing parts, that they are securely fastened, and
that no visible damage exists in addition to any
other criteria mentioned.
1.
Platform Control Console - Placard secure and legi-
ble, control lever and switches return to neutral,
control lever lock and emergency stop switch func-
tion properly, manual in storage box.
2.
Steer Cylinder - See Note
3.
Spindle, Tie Rod, Drive Motor and Steer Linkage
(left front) - See Note
4.
Pothole Protection System - See Note
5.
Battery Compartment - Proper electrolyte level.
6.
Proximity Switch - See Note
7.
Manual Descent - See Note
8.
Wheel and Tire Assembly, Left Rear - See Note
9.
Beacon - See Note
10.
Rotary Switch - See Note
11.
Wheel and Tire Assembly, Right Rear - See Note
12.
Ground Controls - Placard secure and legible, con-
trol switches return to neutral position, emergency
stop switch functions properly. Control markings
legible.
13.
Rotary Switch - See Note
14.
Battery Compartment - Proper electrolyte level.
15.
Hydraulic Pump/Motor, Control Valve Installation -
No unsupported wires or hoses; no damaged or
broken wires - See Note
16.
Lift Cylinder - See Note
17.
Spindle, Tie Rod, Drive Motor and Steer Linkage
(left front) - See Note
18.
Sizzor Arms, Pivot Pins and Sliding Wear Pads (Not
Shown) - See Note
19.
Platform/Handrail Installation (Not Shown) - See
Note
