SECTION 3 - CHASSIS & SCISSOR ARMS
3-12
– JLG Lift –
3121273
3.9 LSS - SCISSOR ARM ANGLE SENSOR -
LOCATION
RS Scissor machines equipped with the Load Sensing
System (LSS) are equipped with a separate scissor arm
angle sensor switch besides the standard elevation limit
switch. This switch communicates with the power control
module in tandem with the lift cylinder pressure switches
to accurately determine platform load for any given plat-
form height.
There is no adjustment to the angle sensor switch and
arm assembly, just install in the proper orientation.
See the LSS Service Manual (3124288) for complete ser-
vice information for the RS Scissors - LSS system.
3.10 TILT SENSOR REPLACEMENT
The tilt sensor is located inside the left side machine cover
(ground control station side).
1932RS/6RS
3248RS/10RS
1.
Platform Gate
2.
LSS Scissor Arm Angle Sensor
(rear plate shown cutaway)
3.
Platform Entry Ladder
1.
Elevation Limit Switch Location
2.
LSS Scissor Arm Angle Switch
(scissor arms shown cutaway)
3.
Platform Entry Ladder
Figure 3-15. LSS - Scissor Arm Angle Sensor - Location Rear of Machine
Figure 3-16. Tilt Sensor Installation
1.
Tilt Sensor
2.
Locating Hole
3.
Mounting Hardware
1
2
3
3
