SECTION 3 - CHASSIS & SCISSOR ARMS
3121273
– JLG Lift –
3-25
Drive Motor Installation
1. Insert the drive motor into the back of the gearbox.
The drive motor will pilot on the four bosses in the
gearbox. Try to keep the end of the motor shaft from
causing damage to the lip seal in the gearbox.
NOTE:
The motor may need to be rotated to line up the sun
gear splines with the motor shaft splines.
2. Install the two motor mounting bolts and washers.
Torque to 9 - 11 ft-lbs (12 - 15 Nm).
3. Connect the end of the Motor Cable to the Power
Module.
4. Fill the gearbox with oil ISO grade 68 oil or oil of a
similar viscosity (80W gear oil or 20W engine oil).
The gearbox will need to be filled with 10 oz of oil.
Figure 3-27. Drive Motor Assembly
1.
Drive Motor
2.
Motor Mounting Bolts
3.
Washers
1
3
2
3
