SECTION 3 - TROUBLESHOOTING
3-10
31215808
1.
On the inside of the outrigger beam, install two nylon
washers on the screw with the two (2) o-rings installed
(one towards jack end)
and three (3) nylon washers on
the other screw
(towards open end of beam)
.
2.
Coat the threads of the screws with Low Strength
Threadlocking Compound and thread the steel acorn
nuts onto each screw. Hold the acorn nuts and tighten
the screws using a cordless screw driver set at the #1
torque setting.
Detent Screws
OUTRIGGER BEAMS are manufactured with a series of holes
drilled around the CONTACTOR PLATE assembly.
OUTRIGGER SOCKETS are equipped with button head screws
(detent screws)
mounted around the CONTACTOR SCREW
HEADS on the floor of the outrigger socket. The detent screws
must align with the holes in the outrigger socket before the
contactor plate on the outrigger beam, and the contactor
screw heads in the bottom of the outrigger socket can make
contact to complete the interlock circuit.
The purpose of this design is to assure the proper size outrig-
ger beams are used with their specific AM model to assure
machine stability, i.e. the machine will not work with the incor-
rect outrigger assemblies.
Go
to
Discount-Equipment.com
to
order
your
parts
