SECTION 2 - GENERAL
3121788
2-3
NOTICE
JLG INDUSTRIES, INC. RECOGNIZES A FACTORY-TRAINED SERVICE
TECHNICIAN AS A PERSON WHO HAS SUCCESSFULLY COMPLETED THE
JLG SERVICE TRAINING SCHOOL FOR THE SPECIFIC JLG PRODUCT
MODEL.
2.2
PREVENTIVE MAINTENANCE AND INSPECTION
SCHEDULE
The preventive maintenance and inspection checks are
listed and defined in the following table. This table is
divided into two basic parts, the “AREA” to be inspected
and the “INTERVAL” at which the inspection is to take
place. Under the “AREA” portion of the table, the various
systems along with the components that make up that
system are listed. The “INTERVAL” portion of the table is
divided into two columns representing the various
inspection time periods. The numbers listed within the
interval column represent the applicable inspection
code for which that component is to be checked.
The checks and services listed in this schedule are not
intended to replace any local or regional regulations
that may pertain to this type of equipment nor should
the lists be considered as all inclusive. Variances in inter-
val times may occur due to climate and/or conditions
and depending on the location and use of the machine.
NOTICE
JLG INDUSTRIES REQUIRES THAT A COMPLETE ANNUAL INSPECTION
BE PERFORMED IN ACCORDANCE WITH THE "ANNUAL MACHINE
INSPECTION REPORT” FORM.
NOTE:
This machine requires periodic safety and mainte-
nance inspections by a qualified JLG mechanic.
Notify JLG dealer if inspection is overdue.
Maintenance and Inspection Schedule Codes:
1. Check for proper and secure: installation, adjust-
ment, or torque.
2. Visual inspection for damage: (cracks, corrosion,
abrasions, distortion, excessive wear, broken welds,
gouges, chafing and threads showing).
3. Proper operation.
4. Check for proper sealing, signs of leakage and fluid
level.
5. Clean and free of debris.
6. Decals installed and legible.
7. Check for proper tolerances, routing, and lubrica-
tion.
8. Fully Charged.
9. Verify/Perform.
Go to
Discount-Equipment.com
to
order your
parts
