SECTION 3 - CHASSIS & SCISSOR ARMS
3-12
3121788
3.5
LOGIC CONTROL MODULE INSTALLATION
All machine electrical functions are controlled through the
logic control module, the logic control module also moni-
tors all the machine’s electrical systems. If a system fault
should happen with the logic module or one of the
machine’s electrical systems, the logic module will gener-
ate a DTC code. Refer to the DTC (Diagnostic Trouble
Codes), see Section 6, Diagnostic Trouble Codes for diag-
nostic information concerning any DTC code generated by
the logic module.
The logic control module is located on the machine chas-
sis inside the right side compartment door.
Module Access
1.
Open the right side compartment to access the
logic control module.
Removing Module from Machine
1.
Disconnect machine power at the positive (+)
battery cable or use quick disconnect, if
equipped.
2.
Mark or note the harness connector positions
before removing from the module.
3.
Disconnect the harness connectors from the
front of the module.
4.
Remove the three bolts, nuts and washers, two
on top and one on bottom of module, to remove
the module from door plate.
Re-install by reversing the above steps.
Figure 3-8. Logic Module Components
1.
Logic Module Assembly
2.
Module Mounting Bolts/Nuts and
Washers
3.
Main Harness Connectors
4.
Clinch Strap
Figure 3-9. Logic Module CO01 - Harness Connector Identification
1.
CO01 - V1 Connector - 8 Pin
2.
CO01 - V2 Connector - 20 Pin
3.
CO01 - V3 Connector - 20 Pin
4.
CO01- V4 Connector - 20 Pin
5.
CO01 - V5 Connector - 20 Pin
NOTE:
For detailed connector pin assignments see the Electrical Schematic in Section 7.
MAF10150
4
1
2
3
MAF11190
1
2
4
3
5
Go to
Discount-Equipment.com
to
order your
parts
