SECTION 3 - CHASSIS & SCISSOR ARMS
3121788
3-43
Figure 3-37. Scissor Arm Assembly (3246R) - Cable Routing (Coiled) (With Foot Switch)
MAF10600
ROUTE ALONG INSIDE
OF CABLE AS SHOWN
CABLE
GUIDE
ROUTE ALONG OUTSIDE
OF CABLE AS SHOWN
CABLE
ROUTE ALONG OUTSIDE
OF CABLE AS SHOWN
CABLE
ROUTE CABLE ALONG
CROSS TUBE OF ARM
STACK. DO NOT LEAVE
EXCESS SLACK OR LOOP
IN THIS AREA
ROUTE THE CABLES IN
CLOCKWISE DIRECION
AROUND LIFT CYLINDER
BUSHING LOOKING
FROM LEFT SIDE. DO
NOT TWIST THE CABLE
SECURE CABLE TO
TUBE SUPPORT ON
CYLINDER. DO NOT
TIE TO CYLINDER
ABOVE 350MM
FROM BLOCK FACE
INCORRECT
WELD NUT
CORRECT
CABLE
CABLE
GUIDE
CABLE
GUIDE
SECURE AC CABLE
TO ARMS USING TIE
WRAPS AT EACH
THE ROUTING PATH
WELDMENT
WELD NUT ALONG
TO THE INBOARD
SECURE CABLE WITH
TIE WRAPS THROUGH
CHASSIS CUTOUT AREA
SECURE CABLE TO
PLATE IF NECESSARY
Go to
Discount-Equipment.com
to
order your
parts
