SECTION 3 - CHASSIS, PLATFORM, & SCISSOR ARMS
31215079
3-53
Ground Control Station Components
DISASSEMBLY
1. Disconnect the harnesses from the ground control
box (1).
2. Open the lid (2) to gain access to components inside
the ground control box.
3. Disconnect any wires and/or plugs from damaged
components (3, 4, or 5).
4. Remove and replace components if necessary.
ASSEMBLY
1. Reattach any wires and/or plugs.
2. Close lid (2) and secure.
3. Reattach machine harnesses to the ground control
box (6).
NOTE:
If tilt sensor or the ground control station box is
removed and replaced, the tilt sensor must be cali-
brated (refer to Section 5.5, Location of Additional
Sensors).
1
1. Ground Control Box
2. Lid
3. Circuit Board
4. Chassis Tilt Sensor
5. Control Switches and Buttons
6. Machine Harness Connectors
Figure 3-44. Ground Control Station Components
Go
to
Discount-Equipment.com
to
order
your
parts
