SECTION 4 - BASIC HYDRAULIC INFORMATION & SCHEMATICS
4-34
31215079
17. Prior to setscrew installation spot drill rod before
installing the setscrew(s) which secure the piston
attaching nut to the diameter groove.
18. Remove the cylinder rod from the holding fixture.
19. Position the cylinder barrel in a suitable holding fix-
ture.
EXTREME CARE SHOULD BE TAKEN WHEN INSTALLING THE CYLINDER
ROD, HEAD, AND PISTON. AVOID PULLING THE ROD OFF-CENTER,
WHICH COULD CAUSE DAMAGE TO THE PISTON AND CYLINDER BAR-
REL SURFACES.
20. With barrel clamped securely, and while adequately
supporting the rod, insert the piston end into the
barrel cylinder. Ensure that the piston loading o-ring
and seal ring are not damaged or dislodged.
21. Continue pushing the rod into the barrel until the
cylinder head gland can be inserted into the barrel
cylinder.
22. If applicable, secure the cylinder head retainer using
a suitable chain wrench.
23. After the cylinder has been reassembled, the rod
should be pushed all the way in (fully retracted) prior
to the reinstallation of any holding valve or valves.
24. If applicable, install the cartridge-type holding valve
and fittings in the port block using new o-rings as
applicable. Refer to Table 4-13, Holding Valve Torque
Specifications.
Sun - 1-1/8 hex 1 - 14 UNS thds
45 - 50 lb-ft
(61 - 68 Nm)
Sun - 1-1/4 hex M36 x 2 thds
150 - 153 lb-ft
(204 - 207 Nm)
Racine - 1-1/8 hex 1-1/16 - 12 thds
50 - 55 lb-ft
(68 - 75 Nm)
Racine - 1-3/8 hex 1-3/16 - 12 thds
75 - 80 lb-ft
(102 - 109 Nm)
Racine - 1-7/8 hex 1-5/8 - 12 thds
100 - 110 lb-ft
(136 - 149 Nm)
Table 4-13. Holding Valve Torque Specifications
Description
Torque Value
Go
to
Discount-Equipment.com
order
your
parts
