SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
2-6
31215084
2.4 WALK-AROUND INSPECTION
Begin the “Walk-Around Inspection” at Item 1, as noted on the
diagram. Continue Left (counterclockwise viewed from top)
checking each item in sequence for the conditions listed in the
following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF” DURING
“WALK-AROUND INSPECTION”.
NOTICE
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE. CHECKING
THIS AREA OFTEN RESULTS IN DISCOVERY OF CONDITIONS WHICH COULD
CAUSE EXTENSIVE MACHINE DAMAGE.
NOTE:
On each item, make sure there are no loose or missing
parts, that they are securely fastened, and that no visible
damage exists in addition to any other criteria mentioned.
1. Platform Control Console
–
Placard secure and legi
-
ble, control lever and switches return to neutral when
activated and released, control lever lock and emer
-
gency stop switch function properly, manual in stor
-
age box.
2. Leveling Jacks
–
See Note
3. Spindle, Tie Rod and Steer Linkage (left front) –
See
Note
4. Wheels and Tires
–
Properly secured, no missing lug
nuts. Refer to section 6, Tires and Wheels. Inspect
wheels for damage and corrosion.
5. Steer Cylinder –
See Note
6. Hydraulic Reservoir
–
Recommended hydraulic fluid
level on level indicator on tank. Breather cap secure
and working.
To
order
go
to
Discount-Equipment.com
