SECTION 5 - ACCESSORIES
31215084
5-7
The optional keyless Programmable Security Lock switch
can be programmed with a four-digit Operator’s Code to
allow only those persons with the code to power-up and
operate the machine.
Machine Power Up
NOTE:
When entering the Operator’s Code on the keypad, a short
beep indicates a properly depressed key, a long beep indi
-
cates an error in depressing key. If an error occurs, restart
the code entry process again.
1.
Enter the programmed four digit Operator’s Code on
the key pad. The ACCEPT - AMBER LED indicator will be
lit if the code is correct.
2.
Press the keypad ON button. The ON - GREEN LED indi
-
cator will light and power will be supplied to the
Ground Control Station.
3.
At the ground control station, turn the main power
selector switch from OFF to either Platform Control
Mode or Ground Control Mode. At the Platform Con
-
trol Console set the key switch to the ON position.
The machine will now operate normally.
Machine Power Down
1.
At the Ground Control Station set the main power
selector switch to the OFF position.
2.
Press the OFF button on the PSL
™
keypad. No LEDs on
the PSL
™
box will be lit.
Changing the Operator’s Code
The Operator’s Code can be changed should the need occur. A
separate Permanent Code matched to the serial number of the
PSL
™
box is included on a sheet in the PSL
™
user manual sup
-
plied with the machine.
1.
Enter the Permanent Code on the key pad. The PRO
-
GRAM - RED LED will be lit if correct code is entered.
NOTE:
ON or OFF cannot be one of the four digits of the new
Operator’s code.
2.
Enter a new four digit Operator’s Code on the keypad.
The ACCEPT - AMBER LED will light up if the new Oper
-
ator’s Code is accepted.
3.
Press the OFF button on the keypad to activate the
new Operator’s Code.
The new Operator’s Code will remain in the PSL
™
even when
power is removed from the equipment, or until that code is
changed again using the Permanent Code.
To
order
go
to
Discount-Equipment.com
