SECTION 3 - MACHINE OPERATION
LIFTPOD by JLG
1001070465
3-15
The powerpack is splash resistant allowing a safe descent if it
starts to rain while the unit is elevated, but JLG does not recom-
mend that the powerpack be used in rain or exposed to water.
Whenever the machine is not in use, set the direction selector to
the
OFF
position.
DISCONTINUE USE OF THE POWERPACK IF A FAULT IS DETECTED.
NOTICE
DO NOT PRESSURE-WASH THE POWERPACK.
MAKE SURE YOU CHECK THE REMAINING CHARGE INSIDE THE POW-
ERPACK’S BATTERY BEFORE ELEVATING THE PLATFORM BY PRESSING
THE CHARGE INDICATOR TEST BUTTON. IF ONLY ONE LIGHT COMES
ON, REPLACE WITH FULLY CHARGED BATTERY.
NOTICE
IF THE POWERPACK DOES NOT ACTIVATE WITH A CHARGED BATTERY
INSTALLED, THE EMERGENCY BUT TON MAY NEED TO BE RESET
(TWIST IN DIRECTION OF ARROWS AND POP OUT).
Elevating
Make sure the pre-start inspection has been completed, the
machine is safe to use, and the base is level.
Move the cordless drill’s direction selector to the "screw-in" (clock-
wise) direction.
Hold the drill’s handle firmly, push it down to automatically disen-
gage the driveshaft interlock, and squeeze the trigger to elevate.
Stop using the cordless drill if any part of it becomes excessively
hot. Wait until drill has cooled down and then continue operation.
Figure 3-20. Cordless drill elevation
Go to Discount-Equipment.com
to order your parts
