SECTION 6 - SPECIFICATIONS AND OPERATOR MAINTENANCE
6-22
31215090
253 DRIVE PREVENTED – CHARGER CONNECTED None
2_5
• DriveState = PREVENTED
•
Driving is not possible since the vehicle is charging.
254 DRIVE & LIFT UP PREVENTED – CHARGER
CONNECTED
None
2_5
• DriveState = PREVENTED
• LiftUpState = PREVENTED
•
Driving and Lifting are not possible since the vehicle is charging and it
is configured to prevent all motion.
255 PLATFORM OVERLOADED
PF: 5000ms ON/
2000ms OFF
GND: 5000ms
ON/2000ms OFF
2_5
• Drive and Lift Restrictions
•
While the Load Sensing System is enabled, the Platform Load mea-
sured by the Load Sensing System is excessive. Functions from Plat-
form Control Station are prevented, and functions from Ground Control
may be prevented, depending on machine configuration.
•
Refer to LSS functionality for Lift and Drive restrictions.
256 DRIVE PREVENTED – POTHOLE NOT
ENGAGED
PF: 500ms On/
500ms Off
GND: 500ms On/
500ms Off
2_5
• DriveState = PREVENTED
•
While elevated, driving is not possible since the control system
detected that the pot-hole protection mechanism failed to deploy.
Clear the obstacle blocking the pot-hole protection mechanism, repair
the mechanical problem, re-adjust the pot-hole limit switches, or
repair the wiring to correct the problem.
•
Alternately, there may be difficulty with the Elevation Angle Sensor
that causes the Control System to improperly believe the platform is
elevated.
2568 TEMPERATURE CUTOUT ACTIVE - AMBIENT
TEMPERATURE TOO LOW
If TransportMode
= TRUE PF: Con-
tinuous
If TransportMode
= FALSE PF: OFF
2_5
• Drive and Lift Restrictions
•
The temperature as communicated by the temperature sensor located
on the temperature/tilt sensor is less than or equal to {PERSONALI-
TIES->TEMP CUTOUT->CUTOUT SET}
•
(See Low Temperature Cutout Functionality)
•
This DTC shall not be displayed in GroundMode, and no restrictions
shall be implemented.
421 POWER MODULE TOO HOT - PLEASE WAIT
None
4_2
• DriveState = PREVENTED
• LiftUpState = PREVENTED
•
Heatsink temperature above 203°F (95° C).
• Possible Cause:
•
Controller is operating in an extreme environment.
•
Excessive load on vehicle.
•
Improper mounting of controller
DTC
Help Message
Alarm
Flash
Code
Action
Trigger
To
order
go
to
Discount-Equipment.com