SECTION 3 - CHASSIS & TURNTABLE
3-96
3121200
3.24
DRIVE ENGAGE CYLINDER
Removal
1.
Tag and disconnect the hoses running to the drive
engage
cylinder. Cap or plug all openings.
2.
Using an adequate supporting device, support the drive
engage cylinder so it doesn’t fall when the pin is
removed.
NOTE:
The drive engage cylinder weighs approximately 26 lbs.
(12 kg).
3.
Remove the retaining pins and pivot pin from the rod
end of the cylinder.
4.
Remove the retaining pins and pivot pin from the barrel
end of the cylinder and remove the cylinder from the
machine.
Installation
1.
Using suitable lifting device, lift the drive engage cylin-
der into position and install the pivot pin and retaining
pin into the barrel end of the cylinder.
NOTE:
The drive engage cylinder weighs approximately 26 lbs.
(12 kg).
2.
Install the pivot pin and retaining pin into the rod end of
the cylinder.
3.
Connect the hydraulic hoses to the drive engage cylin-
der as tagged during removal.
4.
Cycle the drive engage cylinder several times to check
for proper operation and any leakage.
MAE29610
MAE30670
MAE30670
MAE29610
Summary of Contents for T500J
