SECTION 6 - JLG CONTROL SYSTEM
3121200
6-3
If you press
ENTER
, at the
HELP: PRESS ENTER
display,
and a fault is present, the analyzer display will scroll the fault
across the screen. If there was no fault detected, the display
will read:
HELP: EVERYTHING OK.
If powered up at the
ground station, the display will read:
GROUND OK.
If
ENTER
is pressed again, the display moves to the fol-
lowing display:
LOGGED HELP
1: POWER CYCLE (0/0
)
At this point, the analyzer will display the last fault the system
has seen, if any are present. You may scroll through the fault
logs to view what the last 25 faults were. Use the right and left
arrow keys to scroll through the fault logs. To return to the
beginning, press
ESC
two times.
POWER CYCLE (0/0)
indicates a power up.
When a top level menu is selected, a new set of menu items
may be offered: for example:
PLATFORM
GROUND
PUMP
ENGINE
SYSTEM
VALVES
DATALOG
VERSIONS
Pressing
ENTER
with any of the above displayed menus,
will display additional sub-menus within the selected menu. In
some cases, such as
DRIVE
, the next level is the parameter or
information to be changed. Refer to the flow chart for what
menus are available within the top level menus. You may only
view the personality settings for selected menus while in
access level 2. Remember, you may always cancel a selected
menu item by pressing the
ESC
key.
6.3
CHANGING ACCESS LEVEL
When the analyzer is first connected, you will be in access level
2 which enables you to only view most settings which cannot
be changed until you enter a password to advance to a lower
level. This ensures that a setting cannot be accidentally
altered. To change the access level, the correct password must
be entered. To enter the password, scroll to the
ACCESS LEVEL
menu. For example:
MENU:
ACCESS LEVEL 2
Press
ENTER
to select the
ACCESS LEVEL
menu.
Using the
UP
or
DOWN
arrow keys, enter the first
digit of the password, 3.
Then using the
RIGHT
arrow key, position the cursor to
the right one space to enter the second digit of the password.
ESC
ENTER
MAE19060
HELP:
1:POWERCYCLE(0/0)
ESC
ENTER
MAE19060
MENU:
Access level 2
Summary of Contents for T500J
