SECTION 3 – MACHINE CONTROLS AND INDICATORS
31210088
– JLG Lift –
3-11
a.
When lit, indicates that the controls are enabled. If
a function is not actuated within seven seconds, or
a seven seconds lapse between ending one func-
tion and beginning the next function occurs, the
enable light will go out and the enable must be
released and activated again to enable the con-
trols.
When blinking, indicates that the machine is in a
configuration where the current activated function
is not permitted.
b.
Indicates that the high drive cutout limit-speed is
engaged (the mast is out of transport (stowed)
position).
c.
This light indicates that the control system has
detected an abnormal condition. This lamp when
actuated is flashing a DTC (Diagnostic Trouble-
shooting Code). For an explanation of these codes
and items, the operator can or cannot correct, see
Section 6 Diagnostic Trouble Codes (DTC).
d.
When the structure is swung beyond the rear tires
or further in either direction, the Drive Orientation
indicator will illuminate. This is a signal for the oper-
ator to verify that the drive control is being operated
in the proper direction (i.e. controls reversed situa-
tions).
e.
Indicates that the chassis is out of level (refer to
machine specifications for max. allowable slope
angle). If the mast is out of the transport (stowed)
position and the chassis is out of level, an audible
alarm will sound.
f.
(If equipped) - Indicates that the maximum rated
load in the platform is exceeded. In addition to the
warning indicator, an audible alarm sounds. The
platform must be unloaded until the alarm stops.
g.
Indicates that a slack chain condition has been
detected. In addition to the warning indicator, an
audible alarm will sound as long as the chain slack
chain condition exists.
h.
This set of lights indicates the charge level of the
battery.
i.
(If equipped) - Indicates the Soft Touch frame is
against an obstacle. In addition to the warning indi-
cator, an audible alarm sounds. Once illuminated,
only the reverse movement to the one that caused
the contact with the obstacle can be operated in
Creep mode.
Green
Green
Yellow
Yellow
Red
Red
Red
Yellow
Summary of Contents for TOUCAN 10E
