Models
Revision 03-2012
20
Toucan 1210
Toucan 1310
HYDRAULIC SYSTEM
3
3
3.3 Hydraulic filters
NOTE
The filter cartridges must be replaced :
- After the first 50 hours of operation.
- Every 250 hours of operation.
- At each oil change (see chapter 7).
After installation, perform several
movements to bleed the air from the
hydraulic circuit, check the oil level in the
reservoir (PLATFORM FULLY LOWERED)
The return filter must also be replaced.
3.3.2. Return filter
Filtration rating :
10 µm abs
1- Disconnect the battery from the electrical circuit
of the work platform.
2- Unscrew the return filter cap and remove the
spring.
3- Install a new filter cartridge.
4- Check the presence and condition of the O ring,
close the filter cap not forgetting to install the
spring.
The pressure filter must also be replaced.
NOTE
Used oils and filter cartridges must be
disposed of in accordance with the
regulations in force.
3.3.1. Pressure filter
Filtration rating
: 10µm abs.
1- Disconnect the battery from the electrical
circuit of the work platform.
2- Position the release control valve lever on
to release the pressure in the hydraulic
circuit.
3- Unscrew the filter tank
Oil projection on the skin can cause injuries
and burns. Loosen the filter tank very slowly
to allow the oil pressure to drop
progressively.
4- Install a new filter cartridge.
5- Check the presence and condition of the O ring.
6- Install the filter tank.
Fi
lt
er
ca
rt
ri
dg
e
Cap
S
pr
in
g
O
-R
in
g
O
r
in
g
Fi
lt
er
T
an
k
å
DANGER
! CAUTION
! CAUTION
cartridge
å
