8
STEP 7:
Connect the Sensor Wire (26) to the connection wire from the Monitor (50). Use the bracket on the
Mainframe (1) to attach the Monitor (50).
CT100 Monitor Instructions
To reset the monitor back to
‘0’s’
hold down the
‘RESET’
button for 5 seconds until you hear
a bleep from the monitor.
If you see the word
‘SCAN’
flash at the left hand side of the monitor this means the monitor
will automatically skip through the settings so you do not need to keep pressing the button
whilst you are working out.
By pressing
‘MODE’
this will release the monitor from the scan mode. You are then able to
select the mode you wish to view whilst working out. The modes are in the following order:
Distance, Speed and then Time/ Calories.
STEP
8
:
To increase the resistance turn the tension control towards the minus symbol as far as it will go.
Then pull the tension belt. This should increase your tension so you feel more resistance when
turning the tension control knob.
Summary of Contents for CT100
Page 3: ...3 Exploded view ...
