13
13
English
•
Once the distance adjustment has been carried out,
block again the stop stud (W) by using a blocking
stud (Z).
•
Finally, move the slide manually towards the fur-
thest position on the right, and block it by pressing
downwards. Activate the general machine switch
again. Take great care, as when this switch is activa-
ted again the machine will start up instantaneously
until the cutting cycle that had been started before
turning off the machine is completed.
See figure 14
Do not try to start up or handle the machine until all
security aspects, installation instructions, the operating
guide, and maintenance procedures have been conside-
red and understood.
Always cut off the power supply before carrying out any
cleaning or maintenance work.
Always keep the machine and its surroundings clean.
Always work with dry hands.
Protective goggles should be used even if the machine
has protection elements.
Make sure the machine has an earth connection.
In case of emergency, block this switch to stop the cutter
from turning.
Safety recommendations
4.4
3
1
2
4
5
6
7
