background image

5

Using Phoenix Gold

®

 for 

the first time

Before ironing your clothing or fabrics for 
the first time, it is recommended that you 
use Phoenix Gold

®

 on a damp piece of cloth 

for a few minutes. This will ensure that any 
residue left over from the manufacturing 
process is burnt off the Ceramic Plate and 
won’t transfer to your clothes.
You may notice a slight odour and a small 
amount of smoke during this time, but this 
is perfectly normal and should disappear 
quickly.
In hard water areas, we recommend a 
mix of 50% tap water and 50% distilled or 
‘demineralised’ water.
Only use clean, pure water that contains no 
contaminants or additional chemicals.

Important - 

Each iron is checked at the 

factory so some water may remain in the 
tank. 
Please flush the system by filling the 
tank and setting the iron on the highest 
temperature and the maximum steam 
setting. Then allow the steam to flow, in a 
well-ventilated and safe environment, until 
the water tank is empty.
Do this at least once before first use and also 
if you haven’t used your Phoenix Gold

®

 for a 

long period.

Basic instructions

 

1. 

Lift the Water Tank Cap and fill with water. 
When filling the tank from empty, hold 
nearly vertical and, using the jug provided, 

Using Phoenix Gold

®

Note: 

Some water can get trapped inside 

the cap and come out of the small air hole 
when the iron is held vertically. This is not a 
leak, simply open the cap and empty out any 
residual water.
Also, there can sometimes be a noise 
created by air being vented through the air 
hole in the cap. If this occurs, simply open 
the cap to stop it happening.

2.

 Plug Phoenix Gold

®

 into the mains and 

switch on. Ensure the Steam Button is off 
(no light) and the Steam Control Dial is set 
to Min.

Please note: If the Steam Button is on 
before the sole plate has reached the 
required temperature, the iron may spit 
as it heats up. Please keep the Steam 
Button off until the temperature light has 
gone off again.
During use this light will go on/off 
intermediately. This is normal as it is 
a sign the thermostat is regulating the 
iron during use.

fill to the ‘Max’ line on the Phoenix Gold

®

When ‘topping up’ during use, you can 
keep the Phoenix Gold

®

 horizontal and fill 

from the jug as necessary, taking care not 
to overfill. Close the Cap when you have 
finished.

PG_IM_G.indd   5

27/04/2016   13:53

Summary of Contents for Phoenix Gold V16120













Reviews: