Charge cycles:
The charge cycles of new battery chargers have been specially developed to optimise charging of all commer-
cially available batteries. The variety of technologies employed in batteries available today in retail demand
different charging characteristics to ensure correct and complete charging. JMP Skan chargers guarantee the
right charge cycle for every type of battery, thus extending the life of your batteries.
1. First diagnostic step: “Diagnostic I”
(initial diagnosis)
The charger analyses the battery charge level and
the voltage with which it should be charged.
2. First charging step: “Repair Mode”
(desulfation)
Charging with pulse current until the battery has
achieved the optimum voltage and current values
to commence the second charging step.
3. Second charging step: “Initial Charge”
(battery activation)
Charging with reduced, constant current.
4. Third charging step: “Bulk Charge”
(charge with constant current)
Charging with constant current until maximum
battery voltage is achieved.
5. Fourth charging step: “Absorption Charge”
(charge with constant voltage)
Charging with stabilised voltage until current
reaches minimum values.
6. Fifth charging step: “Optimise”
(for recon charging mode only)
Intensive charging phase with constant current
and rising voltage to increase the battery charging
capacity.
7. Second diagnostic step: “Diagnostic II”
(second diagnosis)
The charger checks the status of the charged
battery.
8. Sixth charging step: “Float Mode”
(trickle charging with constant voltage)
Trickle charging with constant, reduced voltage.
9. Seventh charging step: “Trickle Mode”
(trickle charging with pulse current)
Trickle charging with pulse current (constantly
available).
Safety precautions:
JMP Skan chargers are equipped with protective features that ensure maximum safety during operation
and use of the device.
•
Complete protection against sparking
•
Protection against short circuiting
•
Voltage compensation
•
Overheating protection
•
Protection against reverse polarity
•
Protection against weather conditions
(IP65: Protected against total dust ingress and low pressure water jets from any direction)
JM-Products
Hammerbrookstr. 97
20097 Hamburg
Deutschland
Tel.: + 49 (0) 40 2 37 21-0
www.jmproducts.eu
