7
13. Troubleshooting table
Problem
Cause
Solution
Turntable only rotates in one direction or
does not turn at all
Reversing switch does not work
Replace reversing switch
(page 11, part 200-426)
Belt defective
Replace belt
Motor is malfunctioning
Check motor cable or connection on
motor terminal box. Replace motor if it
has malfunctioned
When mounting/dismounting: The clam-
ping jaws do not hold; The jaws open/
close too late
Leakage in compressed air system
Check all parts of compressed air
system
Clamping cylinder does not function
Replace cylinder piston
Worn jaws
Replace jaws
Damaged clamping cylinder discs
Replace discs
Mounting head continually strikes
rim during operation
Locking plate is not correctly adjusted or
is unsuitable
Replace or adjust locking plate
Loose screws on chuck. Vertical moun-
ting arm cannot be engaged by locking
plate
Tighten screws, replace locking plate
Bead breaker blade and jaws opening/clo-
sing pedals cannot be turned back to their
original position
Pedal spring damaged
Replace pedal spring
Bead breaker blade is difficult to handle
Damper jammed
Clean or replace
Disc on bead breaker blade cylinder
damaged
Replace disc
14. Exploded view
201A-1
CX-201-010000-A Machine housing
300-10
C-300-500000-0
Tyre lever buffer
804-D
C-206-080400-D
Pedal front casing
11
B-027-060401-0
Grounding screw M6x40
201-3
CX-201-020000-0 Left-hand casing
12
C-200-580000-0
Lifting lever
4
B-010-060101-0
Hex. socket screw M6x10
200-14
C-200-510000-0
Tyre lever arm rubber
5
B-040-061412-1
Washer Ø6*14*1.2
200-15
C-200-470000-0
Oil/water container
7
B-010-060161-0
Hex. socket screw M6x16
16
B-010-080201-0
Hex. socket screw M8x20
200-9
C-000-001020-0
Rubber buffer
17
B-040-081715-1
Washer Ø8*17*1.5
805-D
B-025-080161-0
Hex. socket screw M8x16
806-D
B-040-081715-1
Washer Ø8*17*1.5
807-D
B-010-060401-0
Hex. socket screw M6x40
