4
QUICK START GUIDE
Place the Fountain on a flat and stable surface within reach of a mains
supply. The Fountain must be completely level to work properly so
adjust the small feet on the base as you need to. Plug the Fountain in.
Set the Heater & Motor switch to on, let it warm up for between 3-5
minutes. The switch will operate with the mains connected , or, via the
charged battery if desired.
When you have heated the bowl, switch off the Heater & Motor to add
your melted chocolate.Once the chocolate has been added, switch
the Heater & Motor back on. You will see the contents start to flow over
the tiers system.
Charging your fountain for cordless use:
The cordless battery pack once fully charged has a maximum life of 60
mins.
To charge ensure the power cord is plugged in and the switch is in the
‘OFF’ position, a full charge takes 3 hour.
The LED light on the fountain will be flashing green during the charging
period. When the LED light changes to solid green the battery is fully
charged.
NB: While charging, the fountain will not run.
On running the fountain in cordless mode, the Led will remain green
until the battery is low, then the LED will display red. The LED will flash red
when the battery has reached the last 5 minutes of its life.
Using your fountain via the mains power supply:
With the power cord plugged in and the fountain switched on to
Heater & Motor or Motor means that the fountain is able to operate
using the power cord.
NB: While running the fountain, the battery pack will not be charged for
cordless running
.
