6
FOUNTAIN ASSEMBLY SQ1
Fig. 1
Fig. 2
Fig. 3
Fig. 4
»
STEP 1
Remove fountain components from their boxes
and place fountain drum on a sturdy, level
surface. Make sure the drum is level so that the
chocolate will flow properly (Fig. 1).
STEP 2
Place auger on top of the square center shaft in
the middle of basin (Fig. 2).
STEP 3
Place the center column onto the centre
housing in the middle of the fountain base (Fig.
3). Ensure that the slot on the column base lines
up with the locating pin on the inside of the
housing.
STEP 4
Place the Tiers on the center column. Large one
first and the small dish last (Fig. 4).
STEP 5
Place the top hat on top of the center column
making sure that the auger pin sits in the middle
of the top hat ring.
Centre & Locating Pins
Slot in column
