Input “20 ” ⇢ Input
“MASTER USER PASSWORD ” ⇢ BLUE LIGHT FLASHES ⇢ Input ”2” ⇢ GREEN
LIGHT FLASHES TWICE ⇢ Input “OLD NORMAL USER PASSWORD ” ⇢ GREEN LIGHT FLASHES TWICE
Input “20 ” ⇢ Input
“MASTER USER PASSWORD ” ⇢ BLUE LIGHT FLASHES ⇢ Input ”3” ⇢ GREEN
LIGHT FLASHES TWICE
Note:
MASTER USER PASSWORD will restore to 11111111.
EN
EN
RESET
If after inputting correct password, the
RED
LIGHT and the BLUE LIGHT flash alternately,
it means the deadbolt is at popup state.
If the
RED LIGHT flashes ceaselessly, it means
the latch can’t popup completely.
NOTE:
The lock leave factory or after resetting will create a temporary password 11111111. After adding
MASTER
USER PASSWORD, the temporary password will be deleted.
Keep pressing
RESET
button [
RESET button
is at the back panel
near the battery case],
when you see the
GREEN LIGHT, please
release the
RESET
button.
Wait for 3
seconds, the
GREEN
LIGHT will flash, it
means reset
successfully.
The
RESET
button has timeout
detection function,
if you keep pressing
more than 5 seconds
(
GREEN LIGHT will
turn off), the reset
operation will fail.
If the lock is in factory
mode without any
configuration it will
emit an alarm when
the display is activated.
After configuring the
user the alarm will be
disable.
Input “10 ” ⇢ Input
“MASTER USER PASSWORD ” ⇢ BLUE LIGHT FLASHES ⇢ Input ”3” ⇢ GREEN
LIGHT FLASHES TWICE ⇢ Input “NEW TEMPORARY USER PASSWORD ” ⇢ GREEN LIGHT FLASHES TWICE
Input “20 ” ⇢ Input
“MASTER USER PASSWORD” ⇢ BLUE LIGHT FLASHES ⇢ Input ”1” ⇢ GREEN
LIGHT FLASHES TWICE ⇢ Input “OLD MASTER USER PASSWORD ” ⇢ GREEN LIGHT FLASHES TWICE
CHANGE / ADD MASTER USER PASSWORD
1 - ADD NORMAL USER PASSWORD
Input “10 ” ⇢ Input “11111111 ” ⇢
BLUE LIGHT FLASHES ⇢ Input ”1” ⇢ GREEN LIGHT FLASHES
TWICE ⇢ Input “NEW MASTER USER PASSWORD ” ⇢ GREEN LIGHT FLASHES TWICE
Note:
After adding the
MASTER USER PASSWORD, the BLUE LIGHT will flash, if you input “1”, you can add the
second group
MASTER USER PASSWORD.
Input “10 ” ⇢ Input
“MASTER USER PASSWORD ” ⇢ BLUE LIGHT FLASHES ⇢ Input ”2” ⇢ GREEN
LIGHT FLASHES TWICE ⇢ Input “NEW NORMAL USER PASSWORD ” ⇢ GREEN LIGHT FLASHES TWICE
Nota:
After adding the
NORMAL USER PASSWORD, the BLUE LIGHT will flash, if you input “2”, you can add the
second group
NORMAL USER PASSWORD.
2 - ADD TEMPORARY USER PASSWORD
4 - DELETE ALL MASTER USER PASSWORD
3 - DELETE SINGLE MASTER USER PASSWORD
5 - DELETE SINGLE NORMAL USER PASSWORD
Manual de instalação /
Installation Manual / Manual de instalación
16/30
www.jnf.pt
Manual de instalação /
Installation Manual / Manual de instalación
17/30
www.jnf.pt
1
2
3
4
2 SECONDS
5
*YOU MUST CHANGE THE MASTER USER PASSWORD TO PERFORM THE FOLLOWING STEPS*
- MI242-3
- MI242-3
