8 -RESET MODE STANDALONE/
20/32
www.jnf.pt
Manual de instalação /
Installation Manual / N
Manual de instalación -
otice d’instructions /
MI190-0
Reset:
This procedure should only be done in case of reconfiguration of the lock.
Note:
In case the reader is installed below the handle no blue light flashes , should be considered
programming time.
1-
Remove the battery cover.
7-
Pass new authorization card
Pass new authorization card
8-
Re-assemble the battery cover and reader.
The lock is ready to be programed again
Return to step 1
2-
Disassemble the reader
IN.20.602.30
IN.20.602.30
5x BLUE
1
2
3
IN.20.602.30
4
S1
4-
Connect external power supply
5-
After 5 blue lights or 5 seconds release
S1 button
6-
emits blue light confirmation.
3-
Press S1 button and maintain.
4-
Connect external power supply
5-
After 5 blue lights or 5 seconds release
S1 button
6-
emits blue light confirmation.
3-
Press S1 button and maintain.
9 -RESET MODO SOFTWARE/
21/32
www.jnf.pt
Manual de instalação /
Installation Manual / N
Manual de instalación -
otice d’instructions /
MI190-0
IN.20.602.30
IN.20.602.30
3x BLUE
1
2
3
IN.20.602.30
4
S1
Reset:
This procedure should only be done in case of reconfiguration of the lock.
Note:
In case the reader is installed below the handle no blue light flashes , should be considered
programming time.
1-
Remove the battery cover.
2-
Disassemble the reader
7-
Re-assemble the battery cover and reader.
The lock is ready to be programed again
CHECK SOFTWARE
EN
EN
