3
PACKAGE CONTENTS
n
V-T8 Connection Terminal x 1
n
Snap-in “Christmas Tree” plugs x 2
n
Snap and lock removable speaker connectors x 9
PREPARING FOR INSTALLATION
The Speakers/Volume Control cables and Amplifier
cables must all reach the proposed location of the
V-T8 distribution connection terminal. Mark the
cables with Wire labels, describing where the cables
originate from, rather than where they will terminate.
Calculating the Impedance
Magnification Setting:
To ensure optimal operation of your amplifier or
receiver, your speakers must show it a load that it
can handle safely and effectively. This requires the
use of impedance-magnifying (IM) volume controls.
CAUTION!
Every speaker pair in the system must be
connected to an impedance-magnifying volume
control and set to the same magnification.
When you install the V-T8 and connect the volume
controls to it, double-check the DIP-switches on the
volume controls to verify that they are set correctly
for the impedance load of your speakers.
Use the following instructions and the accompanying
charts to select the correct DIP switch setting on the
volume controls for the number and type of speakers
in your system.
