Joerns Oxford Mermaid, User Instruction Manual

10

English

Oxford

®

Mermaid & Ranger

7. Assembly and Installation Instructions

WARNING

It is recommended before commencing installation that an architect/structural engineer 

is consulted to verify the structural integrity and suitability of the floor.

CAUTION

It is recommended the installation is performed by a Joerns Healthcare approved dealer 

or competent person.

1.

  Remove all the parts from the carton and place on the floor, taking care to protect the  

  finish from damage.
 

SAFETY NOTE:

 Some of the parts are heavy and will need to be lifted with care. You may  

  need assistance with the heavier assemblies.

2.

  Before commencing assembly establish the seat position required. The drawing on page 5  

  will help clarify whether a left, right or end fit arm is required.

3.

  Having established the position of the seat, assemble the Mermaid seat and safety arms  

  to the chair support arm. These components are fixed together with two stainless steel  

  nuts and bolts.

Mast Positioning:

Baths vary greatly in shape and size. It is very important to establish the exact position of the 

mast in relation to the particular bath.

IMPORTANT NOTE: The lift seat may damage the sides or back of the bath if it is 

incorrectly fitted.

1.

  Place the base plate on the floor in the approximate final position. Locate the mast onto  

  the four base plate fixing studs. Lightly tighten down the nuts onto the studs.

2.

  Connect the seat and arm to the Mermaid column. Secure the seat arm with the safety  

  screw. The whole unit will require supporting during this operation.

3.

  Position the seat in the bath cavity and move the whole assembly until the seat is in the  

  optimum position. This is with the seat on the centre line of the bath with clearance both  

  sides and as far  back as the design of the bath will allow. Make sure there is clearance  

  under the seat and make allowance for some downward movement when the seat is    

  loaded. This will avoid damage to the surface of the bath.

4.

  With the lift in the optimum location, mark the position of the base plate fixing holes.    

  Check the area for hidden services. Remove the base plate from the column, this  

  will make it easier to handle while fixing.