7
2 INSTALLATION
2.1
Install and connect
1. Position the organ on a stable, horizontal
surface.
2. Lean the organ slightly backward.
3. Slide the pedal (A) against the pedalboard of
the organ (B).
4. Put the organ upright.
5. Place the music desk (C) using the music
desk supports in both holes in the stop
panel.
6. Place the organ bench over the pedal.
7. Make sure the voltage of the organ matches
the voltage of the mains. See the serial plate
(D).
8. Connect the organ to an earthed power
socket.
2.2 Switch
on
Switch on the organ with the on/off key switch on the right next to the
manuals.
Wait for a few seconds. Starting the control functions and the settings will
take some time.
The lamps of the SET and 0 buttons light up and the settings appear on
the display.
2.3
Transport and storage
Pay attention to the following during transport and storage:
Remove the music desk and the pedalboard from the organ.
Relative humidity within the storage area: 10-90%.
